Pre-Orders Close Friday July 3rd 2020 at 12 pm MST, 2 pm EST.

00
:
02
:
45
:
55

Steele Anvil Pre-Order
(140 LB)

This anvil is American Made, and the pre-order is the only time you can guarantee you're able to get one. The pre-order is also the only time we will be offering free shipping to your door in the CONUS! These anvils will have a 4-6 month lead time.

When picking an option of anvil below, the sizes are for the limited edition T-Shirt!

Scroll down to check out our anvil stand as well as more anvil details!

If you're interested in purchasing this anvil from outside the US or Canada, please send an email to support@forgedsteele.com and we will get a custom freight quote.


This Pre-Order may be the only chance you have a guarantee that you get one, so we are offering Buy Now Pay Later through Klarna. You can purchase your anvil and stand now and pay it off over 18 months at $91.34 a month.⁠

Click Here for the Anvil Stand

Over thousands of years, blacksmiths have made and adapted tools to make their lives easier. Anvils have taken many forms as a result and have become the most essential blacksmith’s tool.

We set out to refine the iconic London pattern anvil and offer our dream anvil to you. With gorgeous flowing lines, ½” mounting holes, deep hardening steel and more: we’re certain it will be yours too.

This fantastic American Made anvil is cast from a deep hardening martensitic steel, designated as CM40, heat treated and tempered to a nominal 52 Rockwell hardness.

To determine the height for your anvil, a good starting place is to hang your arm by your side and the middle knuckle of your middle finger should be in line with the face of the anvil.

Each pre-order gets the exclusive limited edition t-shirt show below, in addition to their anvil.

Steele Anvil Tripod Stand

The tripod anvil stand is designed to offer a secure platform for your Steele Anvil. The tripod design ensures it stays put and doesn't wobble while also giving the blacksmith clearance to get in close to the anvil from all sides. fabricated from 2x3 0.125 wall tube legs.

The top of this stand has holes for mounting the anvil itself, mounting tool racks, tool trays, and pouring the legs full of sand to deaden the noise.

The feet have a 5/8" hole for either staking to the ground with 1-2' long stakes or bolting to the concrete. We have had the most success with chemical anchors on the threaded rod in concrete.

Click here to check out the anchoring epoxy we use at the shop.

The listed "height" of the anvil stand is the total height from floor to anvil face including your Steele Anvil which is 11". Want your anvil face to be 32" from the ground? Order a 32" stand! The approximate footprint is 22 inches but will vary depending on the height ordered.

These are fabricated right here in Bozeman, Montana, and finished with a hot-wax treatment.

The stand will vary slightly from the photo.

The inset touchmark and lettering on this anvil means that the sides are flush all the way down the sides of the anvil. These anvils are finished in our shop with a 9" radiused edge.

140 LB Steele Anvil

You might also like...

Handle Broach
Handle Broach

Handle Broach

$35.00
Hammer Eye Drift
Hammer Eye Drift
Hammer Eye Drift
Hammer Eye Drift

Hammer Eye Drift

$85.00
Steele Stock Pack
Steele Stock Pack

Steele Stock Pack

$94.50

WARNING

You as the purchaser of the product are acknowledging the risks involved and accepting full responsibility for injury and damages related to its purchase and use. You are therefore releasing our company, employees, and representatives from any and all liability related to its use.